1/72 Pilot's Seat with Seatbelts for I.A.R. 80/81 (Early, used until 1941)
IBG Models 72U045 is a 3D-printed interior set with a pilot's seat with seatbelts for the I.A.R. 80/81 in 1:72 scale. This is the early version used until 1941. It is designed for all IBG Models I.A.R. 80/81 kits and reproduces the frames, seat surfaces and belts of the specified version.
IBG Models 72U045 – a pilot's seat with seatbelts for the I.A.R. 80/81 in 1:72 scale is a 3D-printed replacement for the kit interior parts. The set reproduces the seat frames, upholstery, fittings and belts. This is the early version used until 1941. It is designed for all IBG Models I.A.R. 80/81 kits.
Contents and application
- Aircraft: I.A.R. 80/81
- Scale: 1:72
- Contents: a pilot's seat with seatbelts
- Period: early version used until 1941
- Compatibility: all IBG Models I.A.R. 80/81 kits
- Technology: 3D printing
Recommended procedure
- Check the position of the seats, frames and controls against the kit instructions before removing the parts.
- Remove printing supports gradually with fine cutters or a sharp knife; do not lever against the belts or thin frames.
- Test-fit the parts inside the fuselage and adjust contact surfaces only in small steps.
- Degrease and prime the surface, then paint the seat surfaces, metal frames, belts and buckles separately.
- Fix the assembly with a small amount of cyanoacrylate adhesive; polystyrene cement will not bond the 3D-printed material.
Note: the plastic kit is not included.
Use model paints and primers and adhesives suitable for 3D-printed parts to finish the model.
| Category: | Detail Sets |
|---|---|
| EAN: | 5907747903142 |
| Scale: | 1/72 |
Discussion
Be the first who will post an article to this item!
